week 4 - 3D PRINTING FOR COMPONENTS BOX

 Assalammualaikum for this week i have met Dr Azraie who is the lecturer of Icole Unikl BMI to print the design of my box . Dr Azraie is in level 3 . The printing process took 3 hours .  After 3 hours of printing the one that handle the printing process make a mistake to my printing box .

this is the final look for the box from side. There should be a divider to divide 2 compartments , but the one that in charge pull the divider together with the printed support for box . 

this is for the power supply port ,

this is the look of the lid with holes that fit perfectly for the sensor . 

After checked all the components of the box that been printed . I tried to fit all the components together . So here is the look after fit them 

From the figure above we can see that all the components fit in that box , Since the divider of the box has been pulled out i put the foam to divide those 2 components and i sealed it carefully to avoid short circuit . 

that is all task for this week . For next week I am going to change the use of power supply from use the USB CABLE of android to the battery and i want to redesign the look of my application to make it more friendly user to the blind people since last semester i used the application with button .